Saeco Moltio Product User Manuals & Instructions PDF

Machine Installation

1. Remove the drip tray with grill from the packaging.
2. Remove the machine from the packaging.
3. For best use, it is recommended to: • Choose a safe, level surface, where there is no danger of overturning the machine or being injured. • Choose a location that is suffi ciently well-lit, clean and near an easily reachable socket; • Allow for a minimum distance from the sides of the machine as shown in the illustration.
4. Insert the drip tray with grill into the machine. Make sure it is fully inserted.
   Note: The drip tray collects the water that comes out of the dispensing spout during each rinse/self-cleaning cycle, as well as coff ee that might be spilled during beverage preparation. Empty and wash the drip tray daily and each time the full drip tray indicator is raised.
   Caution: NEVER remove the drip tray when the machine has just been turned on. Wait a couple of minutes for the machine to carry out a rinse/selfcleaning cycle.
5. Push gently on the edge of the water tank door to release the handgrip.
6. Remove the water tank by pulling the handgrip.
7. Rinse the water tank with fresh water.
8. Fill the water tank with fresh water up to the MAX level and slide it back into the machine. Make sure it is fully inserted.
   Caution: Never fill the water tank with warm, hot, sparkling water or any other liquid as this may cause damage to the water tank and the machine.
   Note: Always carry the full water tank as shown in the picture.
9. Remove the coffee bean hopper lid. Slowly pour the coffee beans into the coffee bean hopper.
   Note: The coffee bean hopper contains a tray which vibrates during grinding. This supports the flow of beans into the grinder.
   Caution: Only coffee beans must be put into the coffee bean hopper. Ground coffee, instant coffee, caramelized coffee or any other object may damage the machine.
10. Put back the coffee bean hopper lid on the coffee bean hopper.
11. Insert the plug into the socket located on the back of the machine.
12. Insert the plug of the other end of the power cord into a wall socket with suitable power voltage.
13. Switch the power button to “I” to turn on the machine. The red led next to the “ ” button blinks. Yellow
14. To turn on the machine, simply press the “ ” button. The control panel indicates that the circuit must be primed.