Philips 4400 LatteGo Superautomatic Espresso Machine

Place on a level surface. Fill the 1.8L water tank. Fill the 275g bean hopper. Follow first-use display setup. The 4400 has a color display with intuitive button navigation for its 14 specialty drinks. The LatteGo milk carafe attaches to the machine — fill with cold milk before milk-based recipes.

The 4400 LatteGo is Quiet Mark-certified, features 3 user profiles (plus a guest profile) for personalized drink settings, and an iced coffee mode. It uses Philips' ceramic grinder adjustable in 12 steps.

Install a new AquaClean filter when prompted for up to 5,000 cups without descaling.

14 Specialty Drinks

The 4400 expands on the 3300 LatteGo with 14 recipes including espresso, ristretto, double espresso, coffee, lungo, cappuccino, latte macchiato, flat white, hot milk, iced coffee, americano, and more. Each recipe is accessible from the color display using intuitive navigation buttons.

3 User Profiles

Set up to 3 personal profiles (plus a guest profile) with custom drink preferences — strength, volume, temperature, milk volume. Switch profiles at the start of a session for personalized one-touch brewing without re-entering settings.

LatteGo Milk System

Same two-part LatteGo as the 3300 LatteGo — fills, attaches, rinses in seconds. Compatible with dairy and plant-based milks. Use the milk cleaning button on the machine to run an auto steam-rinse cycle after milk use.

Daily — Coffee Circuit

The 4400 LatteGo automatically rinses at startup and shutdown. Empty the drip tray and grounds container when prompted on the display. Always rinse promptly — overfull grounds containers cause errors.

Daily — LatteGo Milk System

After preparing milk drinks, rinse the LatteGo by removing it and holding both pieces under running water for 15 seconds — the two-part design makes this fast. The LatteGo is also dishwasher safe. For a thorough clean, press the milk cleaning button on the machine which runs a steam rinse cycle automatically.

AquaClean Filter

Install an AquaClean filter in the water tank when prompted. The filter tracks usage via the machine's counter — with the filter installed you can brew up to 5,000 cups without descaling. Replace the filter approximately every 3 months or when the machine prompts you.

Descaling

If you are not using the AquaClean filter, descale when the machine prompts using Philips Saeco descaler tablets or another descaling solution. Follow all on-screen instructions during descaling — the process takes approximately 30 minutes.

Brew Group

Remove and rinse the brew group under warm water weekly. The brew group slides out from the left side of the machine. Rinse only — do not use soap on the brew group. Reinstall when still damp.

Weak Espresso / No Crema

Grind is too coarse or dose is too low. Adjust the grinder one step finer (if the machine allows grind adjustment). Also check bean freshness — stale beans produce less crema.

Machine Not Brewing / Error

Check water tank level, bean supply, and grounds container. Ensure the brew group is properly installed. Most error messages are solved by checking these three items and restarting the machine.

Grounds Container Prompt Too Frequent

The grounds container counts pucks rather than measuring weight. If you're using very fine grounds or double shots, it fills faster. Empty when prompted — waiting causes overflow errors.

AquaClean Not Registering

Ensure the AquaClean filter is fully seated in the water tank and the machine has run a full rinse cycle after installation. The machine must detect the filter before it starts tracking.

Warranty and Support

Philips Saeco superautomatic machines carry a 2-year limited warranty. For warranty service or support, contact Philips at 1-800-243-3846 or visit usa.philips.com/support.